https://community.cisco.com/t5/switching/flow-control-receive-on/td-p/2042977
Flow control is a feature defined in the IEEE 802.3x specification, enabling a receiving device to signal congestion to a sending device, which allows for the sending device to temporarily halt transmission, alleviating congestion at the receiving device
- Flow control— Some Fast Ethernet devices support flow control, where devices can send pause frames, which instruct the remote end to stop sending data for a specific period of time.
- Flow control— Flow control is important for gigabit Ethernet connections, where it is reasonable for the receive buffers on a gigabit interface to become full due to the high speeds of data transfer, causing congestion on the interface
Flow-control administration. Possible settings:
- On indicates the local port requires the far end to send flow control.
- Off indicates the local port does not allow the far end to send flow control.
- Desired indicates the local end allows the far end to send flow control.
흐름 제어는 IEEE 802.3x 사양에 정의 된 기능으로, 수신 장치가 전송 장치로 혼잡을 신호 할 수있게하여 전송 장치가 일시적으로 전송을 중단 할 수있게하여 수신 장치에서의 혼잡을 완화시킵니다.
- 흐름 제어 — 일부 고속 이더넷 장치는 흐름 제어를 지원합니다. 여기서 장치는 일시 중지 프레임을 전송하여 원격 엔드가 특정 시간 동안 데이터 전송을 중지하도록 지시합니다.
- 흐름 제어 — 흐름 제어는 기가비트 이더넷 연결에 중요합니다. 고속 데이터 전송으로 인해 기가비트 인터페이스의 수신 버퍼가 가득 차서 인터페이스에 정체가 발생하는 경우
흐름 제어 관리. 가능한 설정 :
- 켜짐 은 로컬 포트에서 흐름 제어를 전송하기 위해 파 엔드가 필요함을 나타냅니다.
- 꺼짐 은 로컬 포트에서 상대방이 흐름 제어를 전송하지 못함을 나타냅니다.
- 원하는 것은 로컬 끝이 파 엔드가 흐름 제어를 보낼 수 있음을 나타냅니다.